Mar 09, 2023Leave a message

What is the cause of strong vibration of EC centrifugal fan


In industrial production and engineering construction, various extreme situations are often encountered. Such a situation cannot be avoided, but if you want to finish the work normally under such an environment, strong machinery is necessary. EC centrifugal fan is one of them. In this article, we will introduce the causes of strong vibration of EC centrifugal fan.
High-temperature centrifugal fans will have certain vibration due to certain faults when they are used for a long time. There are many reasons for the vibration. Next, we will introduce it in detail:
1. Effect of process piping
The air inlet of high-temperature centrifugal fan is less than 5 m. It is installed in parallel. The distance from the two outlet air ducts to the Yi air duct is about 1.5m, and there is no smooth transition. In this way, the air flow is blocked, especially at the inlet of the high-temperature centrifugal fan, and the recoil effect of the outlet air flow from the outlet of the high-temperature centrifugal fan will also be encountered. It can not be discharged timely and smoothly. The inlet of high-temperature centrifugal fan has a sense of forced pressure. The result of forced pressure intensifies the vibration of the casing, making the vibration of the inlet of high-temperature centrifugal fan significantly higher than that of the outlet of high-temperature centrifugal fan.
2. Impact of high temperature centrifugal fan impeller, shaft and bearing
The static unbalance of the impeller of the high-temperature centrifugal fan is treated. The vibration of the fan shaft is very small, which eliminates the possibility of the fan shell vibration caused by the non-concentricity of the fan shaft and the motor shaft; The bearing temperature and vibration of high temperature centrifugal fan are lower than the specified standard, and there is no noise in the bearing box. This also shows that the bearing is of poor quality or installation: the possibility of vibration caused by qualified bearing is also non-existent. Even if the fan shaft and bearing vibrate, the resulting vibration of the fan shell will not be obvious. Because the shaft, impeller and fan shell have no contact point, the fan shell vibration regularity will not change with the opening of the inlet door.
3. Impact of shell rigidity of high-temperature centrifugal fan
The fan shell has been fixed on the concrete foundation with 40 bolts, meeting the installation requirements; The flange connecting bolts at the inlet and outlet of the high temperature centrifugal fan shall be fully filled with spring pads, and there shall be no abnormal force; The inlet and outlet air ducts of the fan are also firmly fixed, and there is no obvious instability. It should be said that the rigidity of the fan shell and air duct is sufficient. If the assumption is not enough, the natural frequency will be close to the rotating frequency of the impeller, causing resonance and strong vibration.
4. Influence of regulating valve of high temperature centrifugal fan
The regulating valve of high temperature centrifugal fan is composed of l2 guide vanes. Through different connection modes of connecting rod mechanism and guide vanes, the guide vanes can generate clockwise and counterclockwise rotation directions, so that the inlet air of high temperature centrifugal fan can generate clockwise or counterclockwise pre-winding. When the pre-winding direction of the inlet air of the fan is the same as the rotation direction of the impeller, the air flow smoothly enters the impeller, and the vibration of the fan shell is minimal.
To sum up, there are four main reasons for strong vibration of EC centrifugal fan, each of which corresponds to the damage or failure of different parts of EC centrifugal fan. This is a very serious but often overlooked problem, so we must not be careless, and we must solve the problem in a timely manner after finding it.

Send Inquiry

Home

Phone

E-mail

Inquiry