May 18, 2023Leave a message

The Effect of Different Numbers of Lines on Cooling Fans


Cooling fans are mainly used in environments such as high temperature, humidity, and outdoor rain and dust. It can be seen in the market that cooling fans have two, three, and four wires. So, what are the effects of different numbers of wires on the performance of cooling fans?
A common cooling fan is a two wire power cord, which is red and black. The red wire is positive and the black wire is negative, commonly referred to as red positive and black negative. Due to the increasing demand from users for cooling fans, they have continuously developed into three or four lines.
The four lines are mainly the functional signal lines of the cooling fan, one is the RD alarm signal, and the other is the FG speed measurement signal. The RD alarm function is a rotation detection function. During the operation of the cooling fan, the signal pin outputs a low level, and when the rotor is blocked, it outputs a high level; FG speed measurement signal is the input power voltage from a open collector output connected to a "pull-up" resistor and compatible reading equipment. The square wave signal provided by this output is a frequency generator or output tachometer.
In addition, there are PWM speed control signals and temperature control signals. When the temperature control function signal is used, the fan speed is controlled by the temperature when the cooling fan is running, and different temperatures can correspond to different speeds; The PWM speed regulation function can apply frequency and high and low voltage levels to control the speed of the fan. In this function, the frequency can range from 30Hz to 30Khz, the high voltage range can be adjusted from 3V to 10V, and the low voltage range is less than or equal to 0.8 V. The operating speed of the fan can be controlled by adjusting the "duty cycle" to control the fan speed until the fan is at its maximum speed.

Send Inquiry

Home

Phone

E-mail

Inquiry